SKIPPER UNIFIBER FIBERGLASS PRIMER 1-P 0.75L

REF: 183630

One-component primer for low thickness direct application onto fibreglass boat bottoms. Also recommended as a primer coat before antifouling application and as a tie-coat between epoxy or polyurethane two-component paints and one-component finishes. Overcoatable with TOPKAPI enamel for topside and superstructure finish or with appropriate antifouling paint for boat bottom finish.

8 in stock

€19.95

SKU: AE4270X50075 Category:

Description

  • SURFACE PREPARATION AND APPLICATION PROCEDURE
  • Bare Fibreglass. The surface to be coated should be perfectly cleaned, degreased with suitable detergent solution, rinsed with water and slightly sandpapered with fine abrasive paper. Remove dust particles from the surface. Apply 1 coat of UNIFIBER PRIMER and let dry 6-8 hours. After 24 hours apply 1 coat of intermediate undercoat (SOTTOFONDO NAUTICA for topsides or SOLVER PRIMER for the bottom) and let dry as recommended. After 6-8 hours sandpaper the surface and complete the coating system with 2 coats of recommended one-component topcoat enamel for topside and superstructures or 2 coats of antifouling paint for the bottom.
  • Previously Coated Fibreglass with 2-component paint. The pre-existing paint should be in good condition of adhesion to the substrate. Sandpaper and apply 1 coat of UNIFIBER PRIMER and let dry 6-8 hours. Apply 1 coat of intermediate undercoat (SOTTOFONDO NAUTICA for topsides or SOLVER PRIMER for the bottom). After 24 hours sandpaper the surface and complete the coating system with 2 coats of recommended one-component topcoat enamel for topside and superstructures or 2 coats of antifouling paint for the bottom.

You Might Also Like